Flow Timeout - Cisco Nexus 7000 Series Reference Manual

F Commands

flow timeout

To create a Flexible NetFlow flow timeout or to modify an existing Flexible NetFlow flow timeout, use
the flow timeout command. To remove a Flexible NetFlow flow timeout, use the no form of this
command.
Syntax Description
active seconds
aggressive threshold
percentage
fast seconds
threshold packets
inactive seconds
session
seconds
Defaults
The default settings are as follows:
•
•
•
•
•
•
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
OL-25806-03
flow timeout {active seconds | aggressive threshold percentage | fast seconds threshold packets
| inactive seconds | session | seconds}
no flow timeout {active seconds | aggressive threshold percentage | fast seconds threshold
packets | inactive seconds | session | seconds}
Specifies the active or long timeout in seconds. The range is from 60 to
4092. The default is 1800.
Specifies the percentage of the NetFlow table content. The range is from 50
to 99.
Specifies the fast aging timeout in seconds. The range is from 32 to 512. The
default is not supported.
Specifies the packet threshold for a flow timeout in packets. The range is
from 1 to 4000. The default is not supported.
Specifies the inactive or normal timeout in seconds. The range is from 15 to
4092. The default is 15.
Enables TCP session aging.
Flush timeout value in seconds for F2 Series modules. The range is from 5
to 60 seconds.
Active timeout—1800 seconds
Aggressive aging timeout—Disabled
Fast timeout—Disabled
Inactive timeout—15 seconds
Session aging timeout—Disabled
Flush cache timeout – 15 seconds (enabled only on F2)
Cisco Nexus 7000 Series NX-OS System Management Command Reference
flow timeout
207