Action Overbudgetshut - Cisco Nexus 7000 Series Reference Manual

A Commands

action overbudgetshut

To configure the shutdown of a module or the entire switch due to an overbudget power condition when
an Embedded Event Manager (EEM) applet is triggered, use the action overbudgetshut command. To
remove the shutdown configuration, use the no form of this command.
Syntax Description
label
module module
Defaults None
(The default action is to powerdown just the linecards starting from slot_1 till the switch recovers from
overbudget condition. In other words, skip both the supervisors (active and standby) and skip all
spine/xbars, powerdown lcs starting from slot 1 onwards, till the "Available" power recovers from
overbudget condition).
Command Modes
Embedded event manager
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
OL-25806-03
action label overbudgetshut [module module]
no action label overbudgetshut [module module]
Unique identifier that can be any string value. Actions are sorted and run in an
ascending alphanumeric sequence using the label as the sort key. If the string
contains embedded blanks, enclose it in double quotation marks.
(Optional) Forces a shutdown of the specified module.
For 9slot : The range is from 1 to 9.
For 10slot : The range is from 1 to 10.
For 18slot : The range is from 1 to 18.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
action overbudgetshut
11