Ntp Source-Interface - Cisco Nexus 7000 Series Reference Manual

N Commands

ntp source-interface

To configure the Network Time Protocol (NTP) source interface, use the ntp source-interface
command. To remove an NTP source interface, use the no form of this command.
Syntax Description if_index
Defaults
None
Command Modes Global configuration mode (config)
Supported User Roles network-admin
vdc-admin
Command History Release
4.1(3)
Usage Guidelines This command does not require a license.
Examples This example shows how to configure an NTP source interface:
switch(config)# ntp source-interface loopback 1
switch(config)#
This example shows how to remove an NTP source configuration:
switch(config)# no ntp source-interface loopback 1
switch(config)#
Command
show ntp
source-interface
OL-25806-03
ntp source-interface if_index
no ntp source-interface if_index
Source interface.
Modification
This command was introduced.
Description
Displays information about the NTP source interface.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
ntp source-interface
313