Cisco Nexus 7000 Series Reference Manual page 231

F Commands
The netflow-original and original-input keywords are the same and are equivalent to the following
commands:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The original-output keywords are the same as the original-input keywords except for the following:
•
•
This command does not require a license.
Examples This example shows how to create and configure a flow monitor named FLOW-MONITOR-1:
switch(config)# flow monitor FLOW-MONITOR-1
switch(config-flow-monitor)# description monitor location las vegas, NV
switch(config-flow-monitor)# exporter exporter-name1
switch(config-flow-monitor)# record test-record
switch(config-flow-monitor)# netflow ipv4 original-input
OL-25806-03
record-name—Name of a record.
–
netflow ipv4 collection-type—Specifies the traditional IPv4 NetFlow collection schemes as
–
follows:
original-input—Specifies the traditional IPv4 input NetFlow.
original-output—Specifies the traditional IPv4 output NetFlow.
protocol-port—Specifies the protocol and ports aggregation scheme.
netflow-original—Specifies the traditional IPv4 input NetFlow with origin autonomous
–
systems.
match ipv4 source address
match ipv4 destination address
match ip tos
match ip protocol
match transport source-port
match transport destination-port
match interface input
collect counter bytes
collect counter packet
collect timestamp sys-uptime first
collect timestamp sys-uptime last
collect interface output
collect transport tcp flags
collect routing next-hop address ipv4
collect routing source as
collect routing destination as
match interface output (instead of match interface input)
collect interface input (instead of collect interface output)
Cisco Nexus 7000 Series NX-OS System Management Command Reference
flow monitor
203