Cdp Holdtime - Cisco Nexus 7000 Series Reference Manual

C Commands

cdp holdtime

To configure the time that Cisco Discovery Protocol (CDP) holds onto neighbor information before
refreshing it, use the cdp holdtime command. To remove the CDP hold time, use the no form of this
command.
Syntax Description
seconds
Defaults None
Command Modes Global configuration mode (config)
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure a time that CDP holds onto neighbor information:
switch(config)# cdp holdtime 30
switch(config)#
This example shows how to remove the CDP hold time:
switch(config)# no cdp holdtime 30
switch(config)#
Related Commands Command
cdp timer
OL-25806-03
cdp holdtime seconds
no cdp holdtime seconds
Hold time in seconds. The range is from 10 to 255.
Modification
This command was introduced.
Description
Configures the CDP refresh time interval.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
cdp holdtime
39