Snmp-Server Host Use-Vrf - Cisco Nexus 7000 Series Reference Manual

snmp-server host use-vrf

snmp-server host use-vrf
To configure the device to communicate with a Simple Network Management Protocol (SNMP) host
receiver on a specific virtual routing and forwarding (VRF) instance, use the snmp-server host use-vrf
command. To return to the default, use the no form of this command.
Syntax Description
host-address
vrf-name
udp-port port
Defaults
None
Command Modes Global configuration mode
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure Cisco NX-OS to communicate with the host receiver on the blue
VRF.
switch# config terminal
switch(config)# snmp-server host 10.1.1.1 use-vrf blue
Related Commands Command
show snmp
snmp-server host
snmp-server host
filter-vrf
Cisco Nexus 7000 Series NX-OS System Management Command Reference
386
snmp-server host host-address use-vrf vrf-name [udp-port port]
no snmp-server host host-address use-vrf vrf-name [udp-port port]
Name or IP address of the host (the targeted recipient).
Name of the VRF. The name can be any alphanumeric string up to 63
characters.
(Optional) Specifies the port UDP port of the host to use. The range is from
0 to 65535. The default is 162.
Modification
This command was introduced.
Description
Displays SNMP information.
Configures an SNMP host receiver.
Sends only notifications on the specified VRF to the host receiver.
S Commands
OL-25806-03