Cisco Nexus 7000 Series Reference Manual page 210

Nx-os system management command reference
Hide thumbs Also See for Nexus 7000 Series:
Table of Contents

Advertisement

filter (ERSPAN)
filter (ERSPAN)
To configure the filters for an Encapsulated Remote Switched Port Analyzer (ERSPAN) session, use the
filter command. To remove the filters, use the no form of this command.
Syntax Description
access-group
acl-filter
vlan vlan-range
bpdu
true
false
cos cos-value
dest-mac dest-mac
eth-type eth-value
flow-hash
flow-value
pc-lane port-number (Optional) Specifies a filter based on a member of the port channel.
src_mac
mac-address
trace-route
true
false
Defaults
None
Command Modes
config-erspan-src mode
Supported User Roles
network-admin
VDC-admin
Cisco Nexus 7000 Series NX-OS System Management Command Reference
182
filter [access-group acl-filter] [vlan vlan-range] [bpdu [true | false]] [cos cos-value] [dest-mac
dest-mac] [eth-type eth-value] [flow-hash flow-value] [pc-lane port-number] [src_mac
mac-address] [trace-route [true | false]]
no filter [access-group acl-filter] [vlan vlan-range] [bpdu [true | false]] [cos cos-value] [dest-mac
dest-mac] [eth-type eth-value] [flow-hash flow-value] [pc-lane port-number] [src_mac
mac-address] [trace-route [true | false]]
(Optional) Specifies a filter based on an access control group.
(Optional) Specifies a filter based on a VLAN range.
(Optional) Specifies a filter based on the bridge protocol data unit (BPDU) class
of packets.
(Optional) Specifies that a filter based on the bridge protocol data unit (BPDU)
class of packets is used.
(Optional) Specifies a filter based on non-BPDU class of packets.
(Optional) Specifies a filter based on the class of service (CoS) in the dotlq
header.
(Optional) Specifies a filter based on a destination MAC address.
(Optional) Specifies a filter based on the Ethernet type.
(Optional) Specifies a filter based on the result bundle hash (RBH) value.
(Optional) Specifies a filter based on a source MAC address.
(Optional) Specifies a filter based on trace-route packets.
(Optional) Specifies a that a filter based on trace-route packets is used.
(Optional) Specifies a filter based on non trace-route packets.
F Commands
OL-25806-03

Advertisement

Table of Contents
loading

Table of Contents