Show Diagnostic Content Module - Cisco Nexus 7000 Series Reference Manual

Show Commands

show diagnostic content module

To display information about the diagnostic test content for a module, use the show diagnostic content
module command.
Syntax Description module_number
all
Defaults None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines Use the show diagnostic content module command to display information about the tests configured
on the module and the repeat interval time.
Examples This example shows how to display information about the diagnostic test content for a module:
switch# show diagnostic content module 6
Module 6: Supervisor module-1X (Active)
Diagnostics test suite attributes:
B/C/* - Bypass bootup level test / Complete bootup level test / NA
P/*
S/*
D/N/* - Disruptive test / Non-disruptive test / NA
H/*
F/*
X/*
E/*
L/*
T/*
A/I/* - Monitoring is active / Monitoring is inactive / NA
ID
____
OL-25806-03
show diagnostic content module {all | module_number}
Diagnostic content module number. The range is from 1 to 10.
Displays the diagnostic content for all modules.
Modification
This command was introduced.
- Per port test / NA
- Only applicable to standby unit / NA
- Always enabled monitoring test / NA
- Fixed monitoring interval test / NA
- Not a health monitoring test / NA
- Sup to line card test / NA
- Exclusively run this test / NA
- Not an ondemand test / NA
Name
__________________________________ ____________
Cisco Nexus 7000 Series NX-OS System Management Command Reference
Testing Interval
Attributes (hh:mm:ss)
_________________
show diagnostic content module
453