Record Netflow Ipv4 - Cisco Nexus 7000 Series Reference Manual

record netflow ipv4

record netflow ipv4
To select an IPv4 record for the NetFlow monitor, use the record netflow ipv4 command. To remove the
record selection, use the no form of this command.
Syntax Description
original-input
original-
output
protocol-port
Defaults None
Command Modes
NetFlow monitor configuration (config-flow-monitor)
Supported User Roles network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to select a NetFlow IPv4 record for the NetFlow monitor:
switch(config)# switch(config)# flow monitor newflow1
switch(config-flow-monitor)# description recordflow
switch(config-flow-monitor)# record netflow ipv4 original-input
switch(config-flow-monitor)#
This example shows how to remove the NetFlow IPv4 record selection:
switch(config-flow-monitor)# no record netflow ipv4 original-input
Related Commands Command
show flow sw-monitor
Cisco Nexus 7000 Series NX-OS System Management Command Reference
350
record netflow ipv4 {original-input | original-output | protocol-port}
no record netflow ipv4 {original-input | original-output | protocol-port}
Specifies the traditional IPv4 input NetFlow.
Specifies the traditional IPv4 output NetFlow.
Specifies the protocol and ports aggregation scheme.
Modification
This command was introduced.
Description
Displays information about NetFlow monitors.
R Commands
OL-25806-03