Cisco Nexus 7000 Series Reference Manual page 610

show port-monitor
show port-monitor
To display information about the Simple Network Management Protocol (SNMP) port-monitor
configuration, use the show port-monitor command.
Syntax Description policy-name
Defaults None
Command Modes
Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.1(2)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the SNMP port-monitor information:
switch(config)# show port-monitor name pm2
switch(config-port-monitor)# show port-monitor pm2
Policy Name
Admin status : Not Active
Oper status
Port type
--------------------------------------------------------------------------------
-----------
Counter
Use
-------
---- ------
Link Loss
Sync Loss
Protocol Error
Signal Loss
Cisco Nexus 7000 Series NX-OS System Management Command Reference
582
show port-monitor [policy-name]
(Optional) Policy name. The maximum number of alphanumeric characters is 32.
Modification
This command was introduced.
: pm2
: Not Active
: All Ports
Threshold
---------
Delta
Yes
Delta
Yes
Delta
Yes
Delta
Interval Rising Threshold event Falling Threshold
-------- ---------------- ----- ------------------ -
60 5
60 5
60 1
60 5
4 1
4 1
4 0
4 1
Show Commands
event In
4
4
4
4
OL-25806-03