System Test-Preupgrade Running-Ver - Cisco Nexus 7000 Series Reference Manual

S Commands

system test-preupgrade running-ver

To test the running software version before an upgrade, use the system test-preupgrade running-ver
command.
Syntax Description version-number Software version number currently running on the system.
target-ver
target-number
swid
id
impact
impact-number Impact number.
Defaults None
Command Modes Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples
This example shows how to test the running software version before an upgrade:
switch(config)# system test-preupgrade running-ver 4.2<0.202> target-ver Update
swid 4.2.1 impact 0
System will be upgraded according to following table:
Module
------
OL-25806-03
system test-preupgrade running-ver version-number target-ver target-number swid id impact
impact-number
Specifies the target version of the software.
Target version.
Specifies the software ID of the image running on a module: system or kickstart.
Software ID.
Specifies the impact: 0 for hitless and 1 for hitful.
Modification
This command was introduced.
Swid Impact
---------- ----------
6 4.2.1 hitless
1
9 4.2.1 hitless
1
11 4.2.1 hitless
Cisco Nexus 7000 Series NX-OS System Management Command Reference
Running-Version
--------------------
4.2<0.202>
4.2<0.202>
4.2<0.202>
system test-preupgrade running-ver
New-Version Upg-Required
-------------------- ------------
Update
Update
Update
419