Show Hardware Flow Entry; Show Hardware Flow Ip - Cisco Nexus 7000 Series Reference Manual

show hardware flow entry

show hardware flow entry
To display information about a NetFlow table entry, use the show hardware flow entry command.
Syntax Description
address
location
ip
ipv6
detail
module slot-number
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines You must have already enabled traffic monitoring with Flexible NetFlow before you can use the
show hardware flow entry command.
This command does not require a license.
Examples
This example show how to display the NetFlow table entry for module 2:
switch(config)# show hardware flow entry address 0x0 type ip module 2
NT Entry Info (dev_id = 0, nt_entry_addr = 0x00000000):
protocol
profile_id
recir_id
is_routed
from_rp
lkup_dir
ilif(ovld_a)
Cisco Nexus 7000 Series NX-OS System Management Command Reference
502
show hardware flow entry address location type {ip | ipv6} [detail] [module slot-number]
Specifies the NetFlow table address.
Address location of the NetFlow table entry, in hexadecimal. The location
range is from 0x0 to 0x3fffff.
Displays detailed information about the IP flows.
Displays detailed information about the IPv6 flows.
(Optional) Displays detailed information about the flows.
(Optional) Displays information specific to a module.
Modification
This command was introduced.
= 0 (0=IPv4/IPMAC, 1=IPv6, 2=L2, 3=MPLS)
= 0
= 0
= 0
= 0
= 0 (0=Ingress, 1=Egress)
= 0x0
Show Commands
OL-25806-03