Snmp-Server Source-Interface - Cisco Nexus 7000 Series Reference Manual

S Commands

snmp-server source-interface

To configure a Simple Network Management Protocol (SNMP) source interface through which
notifications are sent, use the snmp-server source-interface command. To remove the SNMP source
interface configuration, use the no form of this command.
Syntax Description
traps
informs
ethernet
number
loopback
number
mgmt number
port-channel
number
vlan number
Defaults None
Command Modes Global configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
4.2(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure an SNMP source interface:
switch(config)# snmp-server source-interface traps ethernet 1/1
OL-25806-03
snmp-server source-interface {traps | informs} {ethernet number | loopback number | mgmt
number | port-channel number | vlan number}
no snmp-server source-interface {traps | informs} {ethernet number | loopback number | mgmt
number | port-channel number | vlan number}
Sends SNMP traps through the source interface.
Sends SNMP information through the source interface.
Specifies the Ethernet IEEE 802.3z slot number and port number in this format: 1/1.
The range for the slot number is from 1 to 18, and the range for the port number is
from 1 to 128.
Specifies the virtual interface number. The range is from 0 to 1023.
Specifies the management interface number.
Specifies the port-channel number and the subinterface number in this format: 1.1.
The range for the port-channel number is from 1 to 4096, and the range for the
subinterface number is from 1 to 4093.
Specifies the VLAN interface number. The range is from 1 to 4094.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
snmp-server source-interface
391