Cisco Nexus 7000 Series Reference Manual page 220

filter frame-type fcoe
filter frame-type fcoe
To configure the Fibre Channel over Ethernet (FCoE) frame type filter for the Ethernet Switched Port
Analyzer (SPAN) or Encapsulated Remote Switched Port Analyzer (ERSPAN) session, use the filter
frame-type fcoe command. To remove the FCoE frame type filter, use the no form of this command.
Syntax Description
fc-sid
FC-source-ID
fc-did FC-dest-ID (Optional) Specifies a filter based on an FC destination ID.
fcoe-type
fcoe-value
r-ctl r-ctl-value
sof sof-value
cmd-code
cmd-value
Defaults
None
Command Modes
config-monitor mode (for a SPAN session)
config-erspan-src mode (for an ERSPAN session)
Supported User Roles
network-admin
vdc-admin
Command History Release
6.2(2)
Usage Guidelines
F1 Series modules do not support FCoE source IDs and FCoE destination IDs.
This command does not require a license.
Examples
This example shows how to configure the FCoE frame type filter for a SPAN session:
switch(config)# monitor session 1
switch(config-monitor)# filter frame-type fcoe
Cisco Nexus 7000 Series NX-OS System Management Command Reference
192
filter frame-type fcoe [[fc-sid FC-source-ID] [fc-did FC-dest-ID] [fcoe-type fcoe-value] [r-ctl
r-ctl-value] [sof sof-value] [cmd-code cmd-value]]
no filter frame-type fcoe [[fc-sid FC-source-ID] [fc-did FC-dest-ID] [fcoe-type fcoe-value] [r-ctl
r-ctl-value] [sof sof-value] [cmd-code cmd-value]]
(Optional) Specifies a filter based on an FC source ID.
(Optional) Specifies a filter based on an FCoE type.
(Optional) Specifies a filter based on the routing control flags (R CTL) value.
(Optional) Specifies a filter based on the start of frame (SOF) packets.
(Optional) Specifies a filter based on a command code.
Modification
This command was introduced.
F Commands
OL-25806-03