Table of Contents
Advertisement
Chapter 2 Preparations
2.
Installation and Connection
This section describes how to position the server and connect cables.
2.1
Installation
The environment suitable for the server is as follows.
Hold the server firmly, and slowly and gently place it in the position in which it is to be installed.
The environment that satisfies the
following conditions:
<Operating>
Ambient temperature: 5°C to 40°C*
Humidity: 10% to 85%
Temperature gradient: ±10°C/hour
Air pressure: 749 to 1040 hpa
<Non-operation>
Ambient temperature: 5°C to 40°C*
Humidity: 10% to 85%
Temperature gradient: ±15°C/hour
Air pressure: 749 to 1040 hpa
*: 5°C to 48°C (when an optional
kit is installed; subject to
composition restrictions)
100
Be sure to observe the following precautions to use of the server safely. Failure
to observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety Precautions and Regulatory Notices.
Do not attempt to lift the server by gripping the front bezel.
Install and store only in the specified environment.
At least 150 mm clearance in
front of/behind the server
100/200VAC bipolar grounded
outlet or bipolar outlet with
ground terminal (separate
adapter is required)
Express5800/T110i-S User's Guide
CAUTION
Cables for the mouse or other
devices are within easy reach
A Dust-free, clean, and
organized room
2. Installation and Connection
On a flat and
sturdy desk
Advertisement
Table of Contents
