Figure 1-13 Point Code Determinations - NEC Univerge SV9100 Manual

Issue 2.0
3.4
3.5
SV9100 Networking Manual
Determining which Systems Should be the Central Office
If using a KTS-to-KTS only network and features such as Voice Mail Integration –
K-CCIS are used, the key system that has the voice mail system installed, must
be programmed as the Central/Originating Office. All other key systems must be
programmed as Remote/Destination offices.
Determining Point Codes
Point Codes are used to distinguish an originating office from a destination office
in the K-CCIS network. A Point Code is assigned to each office in the K-CCIS
network. The following guidelines apply when determining the Point Codes:
The Point Code cannot be assigned to more than one office.

The same origination Point Code must be assigned to each K-CCIS channel in

the same system.
The maximum number of Point Codes that can be assigned is 255 (a maximum

of 256 offices can be connected in the same network).

Figure 1-13 Point Code Determinations

Point Code: 00001
CCIS Route 1:00002
CCIS Route 2:00003
Data Assignment for System A

PRG
Route ID
50-02-03
50-02-04
CCIS Route
A
CCIS Route 1
CCIS Route
CCIS Route 1
CCIS
Point Code
1 00001
2 00001
1 00002
2 00003
Point Code: 00002
B
CCIS Route 1:00001
Point Code: 00003
C
CCIS Route 1:00001
Remarks
Assign the Originating Point
Code for System A
Assign the Destination Point
Code for CCH 1
Assign the Destination Point
Code for CCH 2
1-13