Neutral Switch - Honda NC700XA Service Manual

dummyhead dummyhead

NEUTRAL SWITCH

INSPECTION (NC700X/XA/S/SA)
Make sure that the neutral indicator [1] come on with
the ignition switch turned ON and transmission is in
neutral.
If the neutral indicator does not come on, inspect as
follows:
Remove the left rear cover (page 2-29).
Disconnect the neutral switch connector [1].
Check for continuity between the switch terminal and
engine ground.
There should be continuity with the transmission is in
neutral, and no continuity when the transmission is into
gear.
If the continuity inspection is normal, open circuit in
Light green wire between the neutral switch connector
and neutral diode or Light green/red wire between the
neutral diode and neutral indicator.
If the continuity inspection is abnormal, replace the
neutral switch (page 22-28).
INSPECTION (NC700XD/SD)
Make sure that the neutral indicator [1] comes on when
the ignition switch is turned ON and transmission is in
neutral and goes off when the transmission is in gear.
If the neutral indicator does not operate properly, check
the shift indicator blinking with the ignition switch ON
and the engine stop switch " ".
If DTC 52 is indicated with the shift indicator, check the
neutral switch system (page 12-78).
If the shift indicator does not indicate any DTC and the
neutral indicator does not light with the transmission in
neutral, check for open circuit in the Light green wire
between the combination meter and neutral switch.
If the Light green wire is OK, replace the combination
meter assembly.
– NC700XD (page 22-9)
– NC700SD (page 22-9)
LIGHTS/METERS/SWITCHES
[1]
[1]
[1]
22-27