Honda NC700XA Service Manual page 417

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
4. Clutch Line EOP Sensor Inspection
Replace the clutch line EOP sensor with a known
good one (page 12-117).
Connect the clutch line EOP sensor 3P (Black)
connector.
Turn the ignition switch ON with the engine stop
switch " ", lower the sidestand and check the shift
indicator.
Is DTC 9 indicated?
YES
NO
5. Clutch Line EOP Sensor Power/Ground Line
Open Circuit Inspection
Turn the ignition switch OFF.
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the wire harness side
clutch line EOP sensor 3P (Black) connector [1] and
test harness [2] terminals.
Connection: Yellow/red – B14
Is there continuity?
YES
NO
DTC 19 (CKP SENSOR)
• Before starting the inspection, check for loose or
poor contact on the CKP sensor 2P (Red) and PCM
33P connectors, and recheck the DTC.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. CKP Sensor Peak Voltage Inspection at PCM
Connect the ECM test harness to the PCM
connectors (page 4-14).
Turn the ignition switch ON with the engine stop
switch " ".
Crank the engine and measure the CKP sensor
peak voltage between the test harness [1] terminal
and ground.
Connection: B11 (+) – B6 (–)
TOOL:
Imrie diagnostic tester (model 625) or
Peak voltage adaptor [2]
with commercially available digital multimeter
(impedance 10 MΩ/DCV minimum)
Is the voltage more than 0.7 V?
YES
NO
12-62
– Replace the PCM with a known good one
and recheck.
– Faulty original clutch line EOP sensor.
Green/yellow – B22
– Replace the PCM with a known good one
and recheck.
– • Open circuit in the Yellow/red wire
• Open circuit in the Green/yellow wire
07HGJ-0020100
– Replace the PCM with a known good one
and recheck.
– GO TO STEP 2.
[1]
Y/R
G/Y
B14
B6
B11
[1]
[2] B22
[2]