Gearshift Linkage - Honda NC700XA Service Manual

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
Install the CKP sensor rotor [1] on the crankshaft.
• Align the CKP sensor rotor wide groove with the
crankshaft wide tooth.
• Install the CKP sensor rotor with its "MGS" mark [2]
facing out.
Apply engine oil to the primary drive gear mounting bolt
threads and seating surface.
Install the washer [1] and primary drive gear mounting
bolt [2].
Hold the primary drive gear using a special tool and
tighten the primary drive gear mounting bolt to the
specified torque.
TOOL:
Gear holder, 2.5 [3]
TORQUE: 93 N·m (9.5 kgf·m, 69 lbf·ft)
Remove the gear holder.
Install the right crankcase cover (page 11-5).

GEARSHIFT LINKAGE

REMOVAL
Remove the following:
– Left rear cover (page 2-29)
– Right crankcase cover (page 11-5)
Clean the gearshift spindle [1].
Remove the gearshift spindle [1] and washer [2].
11-16
07724-0010100
[1]
[1]
Align
[2]
[2]
[3]
[1]
[1]
[2]