Shock Absorber - Honda NC700XA Service Manual

dummyhead dummyhead
REAR WHEEL/SUSPENSION
BEARING REPLACEMENT
Remove the needle bearings [1] using the special tools.
TOOLS:
Bearing remover set, 17 mm [2] 07936-3710300
Remover handle [3]
Remover weight [4]
Apply molybdenum disulfide grease to new needle
Never install the old
bearings rotating area.
bearing, once the
bearing has been
Install the needle bearings [1] with the marked and dust
removed, the
seal side facing out until it is flush with the shock arm
bearing must be
surface using a hydraulic press and special tools as
replaced with new
shown.
ones.
TOOLS:
Driver [2]
Attachment, 22 x 24 mm [3]
Pilot, 17 mm [4]

SHOCK ABSORBER

REMOVAL/INSTALLATION
Support the motorcycle using a safety stand or hoist,
raise the rear wheel off the ground.
Remove the shroud/side cover (NC700X/XA/XD) (page
2-14).
Remove the shelter/side cover (NC700S/SA/SD) (page
2-15).
Remove the shock arm bolt [1] and nut [2].
Remove the shock absorber lower mounting bolt [3]
and nut [4].
Remove the shock absorber upper mounting nut [1].
Remove the shock absorber upper mounting socket
bolt [2] and shock absorber.
Installation is in the reverse order of removal.
TORQUE:
Shock absorber mounting nut:
44 N·m (4.5 kgf·m, 32 lbf·ft)
Shock arm nut:
44 N·m (4.5 kgf·m, 32 lbf·ft)
18-14
07936-3710100
07741-0010201
[3]
[2]
07749-0010000
07746-0010800
07746-0040400
[3]/[4]
[4]
[1]
[2] [1]
[3]/[4]
[1]/[2]
[1]/[2]