Honda NC700XA Service Manual page 612

dummyhead dummyhead
Install the wire harness from the clamps [1].
NC700X/XA/XD:
Connect the ignition switch 2P (Brown) connector [2]
and immobilizer receiver 4P (Black) connector [3].
Install the following:
– Shroud/side cover (page 2-14)
– Handlebar
– NC700X/XA (page 17-14)
– NC700XD (page 17-17)
Install the combination meter/stay [1], brake hose guide
NC700S/SA/SD:
[2] and socket bolts [3].
• Route the wires, hose and cable properly (page 1-
25).
• Install the brake hose guide against the combination
meter stay.
Connect the combination meter 16P (Gray) connector
[4].
Install the headlight cover (page 2-27).
NC700S/SA/SD:
Connect the ignition switch 2P (Brown) connector [1]
and immobilizer receiver 4P (Black) connector [2].
Install the following:
– Headlight/headlight stay (page 2-27)
– Handlebar
– NC700S/SA (page 17-14)
– NC700SD (page 17-17)
Perform the digital clock set procedure (page 22-14).
FRONT WHEEL/SUSPENSION/STEERING
NC700X/XA:
[1]
[2]
NC700XD:
[2]
NC700S/SA/SD:
[2]/[3]
NC700S/SA/SD:
[2]
[1]
[3]
[1] [1]
[3]
[4] [1]
[3]
[1]
17-41