Tachometer; High Coolant Temperature Indicator/Ect Sensor - Honda NC700XA Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
VS SENSOR REMOVAL/
INSTALLATION
Disconnect the VS sensor 3P (Black) connector [1].
Remove the bolt [2] and VS sensor [3].
Remove the O-ring [4].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.

TACHOMETER

SYSTEM INSPECTION
If the tachometer does not operate, check the following:
– Combination meter system inspection
– NC700X/XA/S/SA (page 22-8)
– NC700XD/SD (page 22-9)
– TXD/RXD line (page 22-11)
– CKP sensor
– NC700X/XA/S/SA (page 5-7)
– NC700XD/SD (page 5-8)
If the above items are OK, replace the combination
meter assembly.
– NC700X/XA/XD (page 22-9)
– NC700S/SA/SD (page 22-9)
HIGH COOLANT TEMPERATURE
INDICATOR/ECT SENSOR
SYSTEM INSPECTION
If the high coolant temperature indicator does not
operate properly, check the following:
– Combination meter system inspection
– NC700X/XA/S/SA (page 22-8)
– NC700XD/SD (page 22-9)
– TXD/RXD line (page 22-11)
– MIL blinking: If the MIL blinks 7, check the ECT
sensor system (page 4-45).
– ECT sensor (page 22-19)
If the above items are OK, replace the combination
meter assembly.
– NC700X/XA/XD (page 22-9)
– NC700S/SA/SD (page 22-9)
If the MIL and engine oil pressure indicator are stay on,
tachometer, high coolant temperature indicator and
HISS indicator does not come on and shift indicator "–"
(NC700XD/SD) is blinking, inspect the following;
– DTC with the HDS (page 4-12)
– TXD/RXD line (page 22-11)
22-18
[1]
[2] [3]
[1]
[4]