Honda NC700XA Service Manual page 314

dummyhead dummyhead
Installation is in the reverse order of removal.
• Replace the cylinder head cover packing with a new
one.
• Check the mounting rubbers [1] are in good
condition, replace them if necessary.
• Install the mounting rubbers with their "UP" mark [2]
facing up.
• Route the wire harness and hoses properly (page 1-
25).
• Make sure the radiator mounting rubber slits facing
down.
• Align radiator lower stay slit with cylinder head tab.
TORQUE:
Cylinder head cover socket bolts:
10 N·m (1.0 kgf·m, 7 lbf·ft)
DISASSEMBLY/ASSEMBLY
Remove the breather plate mounting bolts [1].
Remove the breather plate [1] and gasket [2].
Assembly is in the reverse order of disassembly.
• Replace the breather plate gasket with a new one.
• Apply locking agent to the breather plate mounting
bolt threads (page 10-3).
TORQUE:
Breather plate mounting bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
CYLINDER HEAD/VALVES
[2]
[1]
[1]
[2] [1]
10-7