Honda NC700XA Service Manual page 353

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
Install the setting plate [1] and a new bolt [2].
Align the setting plate hole with the crankcase boss.
Install the following:
– Return spring [1]
– Stopper arm [2]
– Washers [3]
– Shift drum stopper arm pivot bolt [4]
• Apply locking agent to the shift drum stopper arm
pivot bolt threads (page 11-3).
• Align the return spring hook [5] with stopper arm cut-
out.
• Install the stopper arm with its "MGS" mark [6] facing
out.
TORQUE:
Shift drum stopper arm pivot bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
Hold the stopper arm [1] with a screwdriver.
Install the dowel pin [2] into the shift drum hole.
Install the shift drum stopper plate [3] while aligning its
slit with the dowel pins.
Apply locking agent to the shift drum center socket bolt
threads (page 11-3).
Install and tighten the shift drum center socket bolt [1] to
the specified torque.
TORQUE: 23 N·m (2.3 kgf·m, 17 lbf·ft)
11-18
Align
[1]
[1]
[5]
[3]
Align
[1]
[2]
[2] [3]
[4]
[6]
[2]
[1]