Honda NC700XA Service Manual page 740

dummyhead dummyhead
Turn the ignition switch ON with the engine stop switch
" ".
Measure the voltage at the combination meter 16P
(Gray) connector [1] of the wire harness side.
CONNECTION: Pink/green (+) – Green/red (–)
Slowly turn the rear wheel by hand.
There should be 0 to 5 V pulse voltage.
– If pulse voltage appears, replace the combination
meter assembly.
– NC700XD (page 22-9)
– NC700SD (page 22-9)
– If pulse voltage does not appear, the Pink/green wire
has an open circuit.
VS SENSOR SIGNAL LINE
INSPECTION (NC700X/XA/S/SA)
Remove the windscreen (page 2-23).
Disconnect
connector [1].
Disconnect the VS sensor 3P (Black) connector [1].
Check for continuity between the combination meter
16P (Gray) connector [1] and VS sensor 3P (Black)
connector [2] of the wire harness side.
CONNECTION: Pink/green – Pink/green
If there is no continuity, check for open circuit in Pink/
green wire and loose contact of the wire harness
connectors.
the combination meter
LIGHTS/METERS/SWITCHES
[1]
NC700X/XA:
16P (Gray)
[2]
P/G G/R
[1] NC700S/SA:
P/G P/G
22-17
[1]
[1]
[1]