Honda NC700XA Service Manual page 400

dummyhead dummyhead
5. Inner Mainshaft Sensor Ground Line Open
Circuit Inspection
Disconnect the PCM 33P (Gray) connector.
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Gray) connector [2] terminals.
Connection: Green/yellow – B22
TOOL:
Test probe
Is there continuity?
YES
NO
6. Inner Mainshaft Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Connection: Gray/yellow – A20
TOOL:
Test probe
Is there continuity?
YES
NO
7. Inner Mainshaft Sensor Output Line Short
Circuit Inspection
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1]
terminal and ground
Connection: Gray/yellow – Ground
Is there continuity?
YES
NO
8. Inner Mainshaft Sensor Inspection
Turn the ignition switch OFF.
Replace the inner mainshaft sensor with a known
good one (page 12-115).
Erase the DTCs (page 12-13).
Test-ride the motorcycle and stop the engine.
Check the DTC with the HDS pocket tester.
Is DTC 53-1 indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
07ZAJ-RDJA110
– Replace the PCM with a known good one,
and recheck.
– Open circuit in the Green/yellow wire
07ZAJ-RDJA110
– GO TO STEP 7.
– Open circuit in the Gray/yellow wire
– Short circuit in the Gray/yellow wire
– GO TO STEP 8.
– Replace the PCM with a known good one,
and recheck.
– Faulty original inner mainshaft sensor
G/Y
[1]
[2]
A20
[1]
[2]
B22
Gr/Y
[1]
Gr/Y
12-45