Pillion Seat; Single Seat - Honda NC700XA Service Manual

dummyhead dummyhead

PILLION SEAT

REMOVAL/INSTALLATION
Open the pillion seat [1] using the ignition key.
Remove the nuts [2], collars [3] and pillion seat.
Remove the grommets [4] from the pillion seat stay.
Installation is in the reverse order of removal.
Apply grease to the pillion seat catch hook sliding area
if necessary.

SINGLE SEAT

REMOVAL/INSTALLATION (NC700X/
XA/XD)
Open the pillion seat using the ignition key.
Remove the mounting bolts [1].
Remove the single seat [2] by pulling it rearward.
Remove the collars [3] and grommets [4] from the
single seat.
Install the grommets and collars to the single seat.
Install the single seat by inserting its hook [5] into the
seat bracket [6] under the luggage box hinge bracket.
Install and tighten the mounting bolts securely.
Close the pillion seat.
REMOVAL/INSTALLATION (NC700S/
SA/SD)
Open the pillion seat using the ignition key.
Remove the mounting socket bolts [1] and washers [2].
Remove the single seat [3] by pulling it rearward.
Remove the collars [4] and grommets [5] from the
single seat.
Install the grommets and collars to the single seat.
Install the single seat by inserting its hook [6] into the
seat bracket [7] under the luggage box hinge bracket.
Install and tighten the mounting socket bolts securely.
Close the pillion seat.
FRAME/BODY PANELS/EXHAUST SYSTEM
[2]/[3]
[5]
[6]
[6]
[7]
[1]
[4]
[2] [1]
[3]/[4]
[3] [1]/[2]
[4]/[5]
2-7