Honda NC700XA Service Manual page 332

dummyhead dummyhead
Install the valve cotters using the special tool as shown.
TOOL:
Valve spring compressor
• To prevent loss of tension, do not compress the
valve spring more than necessary.
• Grease the cotters to ease installation.
Tap the valve stems gently with plastic hammer and
shaft as shown to seat the cotters firmly.
Support the cylinder head above the work bench
surface to prevent possible valve damage.
Install the insulator [1] while aligning its slit with cylinder
head tab.
Tighten the band screw [2] to the specified range.
Install the following:
– Camshaft (page 10-15)
– Injector (page 7-21)
– Spark plug (page 3-8)
– Cylinder head (page 10-25)
INSTALLATION
Install the partition plate [1] to the No.1 cylinder intake
side.
Install the partition plate with its tab [2] side facing
inside.
07757-0010000
CYLINDER HEAD/VALVES
[1]
11 – 13 mm
(0.4 – 0.5 in)
[2] Align
[2] [1]
10-25