Brake Fluid Replacement/Air Bleeding (Nc700Xa/Xd/Sa/Sd) - Honda NC700XA Service Manual

dummyhead dummyhead
BRAKE FLUID REPLACEMENT/AIR
BLEEDING (NC700XA/XD/SA/SD)
• Do not allow foreign material to enter the system
when filling the reservoir.
• When using a commercially available brake bleeder,
follow the manufacture's operating instructions.
BRAKE FLUID DRAINING
LEVER BRAKE LINE
Turn the handlebar until the reservoir is parallel to the
ground.
Remove the reservoir cover screws [1], reservoir cover
[2], set plate [3] and diaphragm [4].
Connect a bleed hose [1] to the front brake caliper
upper bleed valve [2].
Loosen the upper bleed valve and pump the brake lever
until no more fluid flows out of the bleed valve.
PEDAL (COMBI) BRAKE LINE
Support the motorcycle in an upright position.
Remove the rear brake reservoir mounting bolt [1] and
reservoir [2].
Remove the cover screws [3], reservoir cover [4], set
plate [5] and diaphragm [6].
Temporarily install the reservoir and mounting bolt to
the reservoir stay lower hole [7] using a 6 mm nut [8].
Align the reservoir tab [9] with the reservoir stay cut out
[10].
HYDRAULIC BRAKE
[1]
[2]
[1]
[2]
[8]
[10]
[2] [1] [7]
[3]/[4]
[3]
[4]
[5]
[6]
[2] [9] [1]
19-11