Honda NC700XA Service Manual page 435

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
2. Inner Mainshaft Sensor Output Line Inspection
Measure the voltage between the wire harness side
inner mainshaft sensor 3P (Black) connector [1]
terminal and ground.
Connection: Gray/yellow (+) – Ground (–)
Is the voltage within 4.75 – 5.25 V?
YES
NO
3. Inner Mainshaft Sensor Input Line Open Circuit
Inspection
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
test harness [2] terminals.
Connection: Brown/yellow – A14
Is there continuity?
YES
NO
4. Inner Mainshaft Sensor Ground Line Open
Circuit Inspection
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
test harness [2] terminals.
Connection: Green/yellow – B22
Is there continuity?
YES
NO
12-80
– GO TO STEP 7.
– GO TO STEP 5.
– GO TO STEP 4.
– Open circuit in the Brown/yellow wire
– Replace the PCM with a known good one,
and recheck.
– Open circuit in the Green/yellow wire
[1]
Gr/Y
[1]
Br/Y
[1]
G/Y
A14
[2]
[2]
B22