Honda NC700XA Service Manual page 611

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
Install the top bridge [1].
Install the following:
NC700X/XA/XD:
– Brake hose [2]
– Right handlebar switch wire harness clamp [3]
– Throttle cables [4]
– Left handlebar switch wire harness clamp [5]
– Clutch cable (NC700X/XA) [6]
– Parking brake cable (NC700XD) [6]
Route the wires, hose and cable properly (page 1-25).
Install the steering stem nut [1], but do not tighten the
steering stem nut yet.
Install the fork legs (page 17-33).
Tighten the steering stem nut to the specified torque.
TORQUE: 103 N·m (10.5 kgf·m, 76 lbf·ft)
Turn the steering stem left and right, lock-to-lock
several times to make sure the steering stem moves
smoothly without play or binding.
Install the cap to the steering stem nut.
Install the brake hose clamp [1] and bolt [2] to the
NC700X:
bottom bridge.
Be sure to rest the brake hose clamp against the
bottom bridge tab [3].
Install the ignition switch wire harness clamp [1] and
NC700X/XA/XD:
immobilizer receiver wire harness clamp [2].
17-40
[6] [5] [2]
[1]
[1]
NC700X: [2]
[1]
NC700X/XA/XD:
[1]
[4]
[3]
[3]
[2]