Horn - Honda NC700XA Service Manual

dummyhead dummyhead
REMOVAL/INSTALLATION
Remove the shroud/side cover (NC700X/XA/XD) (page
2-14).
Remove the shelter/side cover (NC700S/SA/XD) (page
2-15)
Disconnect the sidestand switch 3P (Green) connector
[1].
Remove the sidestand switch wire clamp [2].
Remove the wire band [1] and sidestand switch wire
clamp [2].
Remove the sidestand switch mounting bolt [1] and
sidestand switch [2].
Installation is in the reverse order of removal.
• Replace the sidestand switch mounting bolt with a
new one.
• Align the sidestand switch tab with the sidestand
hole.
• Align the sidestand switch groove with the return
spring holding pin.
• Route the wire properly (page 1-25).

HORN

INSPECTION
Remove the lower cowl (page 2-28).
Disconnect the wire connectors [1] from the horn [2].
Connect the 12 V battery to the horn terminal directly.
The horn is normal if it sounds when the 12 V battery is
connected across the horn terminals.
LIGHTS/METERS/SWITCHES
[1]
NC700X/XA/S/SA: [1] NC700XD/SD:
[2]
[2]
[1]
Align
Battery
[2]
[1]
[2]
Align
[2]
[1]
22-29