Honda NC700XA Service Manual page 522

dummyhead dummyhead
Apply locking agent to the crankcase 8 x 45 mm bolt
threads (page 14-6).
Install and tighten the crankcase bolts to the specified
torque in a crisscross pattern in 2 or 3 steps.
TORQUE:
Crankcase 10 mm bolt [1]:
39 N·m (4.0 kgf·m, 29 lbf·ft)
Crankcase 8 mm bolt [2]:
24 N·m (2.4 kgf·m, 18 lbf·ft)
Crankcase 8 x 45 mm bolt [3]:
24 N·m (2.4 kgf·m, 18 lbf·ft)
Crankcase 6 mm bolt [4]
12 N·m (1.2 kgf·m, 9 lbf·ft)
Place the engine with the lower side down.
Install the crankcase 8 mm bolts [1] and a new sealing
washer [2].
The sealing washer location is indicated on the upper
crankcase by the " " mark.
Tighten the crankcase 8 mm bolts to the specified
torque.
TORQUE: 24 N·m (2.4 kgf·m, 18 lbf·ft)
Install the cam chain [1] to the crankshaft.
Install the removed parts in the reverse order of
removal (page 14-4).
CRANKCASE/TRANSMISSION/BALANCER
[3]
[2]
[1]
[1]
[4]
[1]
[1]/[2]
14-31