Honda NC700XA Service Manual page 623

dummyhead dummyhead
REAR WHEEL/SUSPENSION
Drive in a new right side bearing [1] squarely until it is
Never install the old
fully seated.
bearing, once the
bearing has been
TOOLS:
removed, the
Driver [2]
bearing must be
Attachment, 42 x 47 mm [3]
replaced with new
ones.
Pilot, 20 mm [4]
Install the distance collar [5].
Drive in a new left side bearing [6] squarely until it is
seated on the distance collar.
Drive the rear wheel distance collar B [1] to a new
driven flange bearing [2].
TOOLS:
Driver [3]
Attachment, 28 x 30 mm [4]
Pilot, 20 mm [5]
Drive in the driven flange bearing/collar [1] squarely
with its collar side facing down until it is fully seated.
TOOLS:
Driver [2]
Attachment, 42 x 47 mm [3]
Pilot, 20 mm [4]
Install the driven sprocket [1] to the driven flange.
Install the driven sprocket with its marked side facing
out.
Temporarily install the driven sprocket nuts [2].
18-10
[5]
07749-0010000
07746-0010300
07746-0040500
07749-0010000
07946-1870100
07746-0040500
07749-0010000
07746-0010300
07746-0040500
[1]
[1]
[6]
[1]
[2]
[3]/[4]
[3] [4]/[5]
[1]
[2]
[2]
[3]/[4]
[2]