Rear Fender A; Rear Fender B - Honda NC700XA Service Manual

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM

REAR FENDER A

REMOVAL/INSTALLATION
Remove the following:
– Pillion seat (page 2-7)
– Mud guard (page 2-11)
Remove the clip [1], washer [2], spring [3] and pillion
seat hinge [4] from the pillion seat stay.
Remove the rubber holder [5] from the rear fender A
tabs.
Remove the socket bolts [6], pillion seat stay [7] while
holding the rear fender A [8].
Remove the rear fender A and release the wire
harnesses.
Installation is in the reverse order of removal.
Route the wire harness properly (page 1-25).

REAR FENDER B

REMOVAL/INSTALLATION
Remove the following:
– Rear fender A (page 2-12)
– Shroud/side cover (NC700X/XA/XD) (page 2-14)
– Shelter/side cover (NC700S/SA/SD) (page 2-15)
Remove the bolt [1] and rear brake reservoir stay/reservoir [2].
Remove the socket bolts [3].
Release the tab [4] from the frame.
Release the main wire harness [5] from guides [6] and remove the rear fender B [7].
Installation is in the reverse order of removal.
• Align the rear brake reservoir stay with the frame tab.
• Route the wire harness properly (page 1-25).
[1]
Align
2-12
[2]
[3]
[1]
[2]
[3]
[4]
[6]
[8]
[4]
[5] [6]
[7]
[5]
[7]