Honda NC700XA Service Manual page 601

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
ASSEMBLY
DUST SEAL
STOPPER RING
OIL SEAL
BACK-UP RING
GUIDE BUSHING
SLIDER BUSHING
FORK SLIDER
20 N·m (2.0 kgf·m, 15 lbf·ft)
Install the slider bushing [1] being careful not to damage
Do not open the
the coating of the bushing, if it has been removed.
bushing slit more
than necessary.
Remove the burrs from the bushing mating surface,
being careful not to peel off the coating.
Apply fork fluid to a new oil seal lips.
Install the oil seal
Install the guide bushing [2], back-up ring [3] and oil
with its marked side
seal [4] onto the fork pipe.
facing up.
Install the rebound spring [1] to the fork piston [2] and
install them into the fork pipe [3].
17-30
SEALING WASHER
FORK PISTON RING
FORK PISTON
REBOUND SPRING
FORK PIPE
OIL LOCK PIECE
[4]
22 N·m (2.2 kgf·m, 16 lbf·ft)
O-RING
SPRING COLLAR
SPRING SEAT
FORK SPRING
[3] [2] [1]
[1] [2] [3]