Brake Light Switch; Brake Lock Operation (Nc700Xd/Sd) - Honda NC700XA Service Manual

dummyhead dummyhead
MAINTENANCE
If the brake pedal [1] is adjusted to the lower position
[2], make sure that the clearance between the lower
end of the push rod and the brake pedal does not fall
below 1 mm (0.04 in).
If the brake pedal is adjusted to the higher position [3],
make sure that the lower end of the push rod thread [4]
is visible inside the joint.
After adjustment, tighten the rear master cylinder push
rod lock nut to the specified torque.
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)

BRAKE LIGHT SWITCH

Adjust the brake light switch [1] so that the brake light
The front brake light
comes on just prior to the brake actually being
switch does not
engaged.
require adjustment.
If the light fails to come on, adjust the switch so that the
light comes on at the proper time.
Hold the switch body and turn the adjuster [2]. Do not
turn the switch body.
BRAKE LOCK OPERATION (NC700XD/
SD)
INSPECTION
Support the motorcycle using a safety stand or hoist,
raise the rear wheel off the ground.
Turn the rear wheel with your hands and pull the
parking brake lever [1] slowly.
Check the parking brake lever " " mark [2] within the
index lines [3] at the rear wheel stopped.
If the parking brake lever " " mark not within the index
lines, adjust the parking brake as follows (page 3-25).
3-24
[2] [3]
[4]
1 mm
(0.04 in)
[4]
[1]
[1]
[2]
[2]
[3]
[1]