Honda NC700XA Service Manual page 567

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
Install the fuel feed hose [1] to the clamp [2].
Connect the linear solenoid valve 4P (Green) connector
[3] and shift spindle angle sensor 3P (Gray) connector
[4] and install them to the ABS modulator stay.
Connect the ECT sensor 2P connector [1].
Connect the water hose [2] to the thermostat cover.
Align the water hose paint mark with the thermostat
cover tab.
Install the main wire harness [3] to the stay [4] and
frame [5].
Tighten the water hose band screw to the specified
range.
Connect the clutch EOP sensor 3P connectors [1].
Install the clamps [2] and bolts [3].
Tighten the bolts securely.
16-24
[3]
[4] [2]
[4] Align
[1] [3]
0 – 1 mm
(0 – 0.04 in)
[2]/[3]
[1]
[2]
[5]
[1]