Starter Motor - Honda NC700XA Service Manual

dummyhead dummyhead
ELECTRIC STARTER

STARTER MOTOR

REMOVAL/INSTALLATION
Disconnect the battery negative cable (page 21-6).
Release the rubber cap [1].
Remove the starter motor terminal nut [2] and starter
motor cable [3].
Remove the stater motor mounting bolts [4] and ground
cable [5].
Remove the starter motor [6].
Remove the O-ring [1].
Installation is in the reverse order of removal.
• Apply engine oil to a new O-ring.
• Route the cables properly (page 1-25).
TORQUE:
Starter motor terminal nut:
10 N·m (1.0 kgf·m, 7 lbf·ft)
DISASSEMBLY/ASSEMBLY
FRONT COVER
O-RING
BOLTS
SCREW
6-8
MOTOR CASE
SEAL RING
NEGATIVE BRUSHES
POSITIVE BRUSHES
ARMATURE
TERMINAL BOLT
[4]
SEAL RING
BRUSH HOLDER
REAR COVER
SPRING
[1] [2]/[3]
[4]/[5] [6]
[1]
O-RING
NUT
WASHER
INSULATOR
TERMINAL STOPPER