At/Mt Mode Switch Troubleshooting - Honda NC700XA Service Manual

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
AT/MT MODE SWITCH
TROUBLESHOOTING
If the engine can be started but AT/MT mode cannot be
changed, perform this troubleshooting.
• Before starting the inspection, check for loose or
poor contact on the right handlebar switch and PCM
33P connectors, and recheck the AT/MT mode
switch operation.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. AT/MT mode switch Power Input Voltage
Inspection
Disconnect the following:
– Right handlebar switch 6P (Black) connector
(NC700XD) [1]
– Right handlebar switch 7P (Green) connector
(NC700SD) [2]
Turn the ignition switch ON with the engine stop
switch " ".
Measure the voltage between the wire harness side
right handlebar switch connector terminal and
ground.
Connection: Black/white (+) – Ground (–)
Is there battery voltage?
YES
NO
2. AT/MT mode switch Inspection
Turn the ignition switch OFF.
Check for continuity between the switch side right
handlebar switch connector [1] terminals in each
switch position.
Connection: Black/white – Blue/black
Is there continuity with the switch pushed and
no continuity with the switch released?
YES
NO
12-96
– GO TO STEP 2.
– Open circuit in the Black/white wire
between the right handlebar
connector and fuse/relay box (FI fuse)
– GO TO STEP 3.
– Faulty AT/MT mode switch
NC700XD:
[1]
Bl/W
switch
NC700XD:
Bl/W
Bu/Bl
NC700SD:
Bl/W
Bu/Bl
NC700SD:
[2]
Bl/W
[1]
[1]