Honda NC700XA Service Manual page 704

dummyhead dummyhead
2. Power Input Line Short Circuit Inspection
Turn the ignition switch OFF.
Disconnect the ABS modulator 25P connector [1].
With the ABS fuse 7.5 A (ABS MAIN) removed,
check for continuity between the ABS modulator
25P connector of the wire harness side and ground.
Connection: Red/black – Ground
TOOL:
Test probe
Is there continuity?
YES
NO
3. Power Input Line Open Circuit Inspection
Turn the ignition switch OFF.
Disconnect the ABS modulator 25P connector [1].
Turn the ignition switch ON and engine stop switch
" ".
Measure the voltage between the ABS modulator
25P connector of the wire harness side and ground.
Connection: Red/black (+) – Ground (–)
Standard:
TOOL:
Test probe
Does the standard voltage exist?
YES
NO
4. Failure Reproduction
Turn the ignition switch OFF.
Connect the ABS modulator 25P connector.
Erase the problem code (page 20-9).
Test ride the motorcycle above 30 km/h (18 mph).
Retrieve the problem code (page 20-8) and recheck
the ABS indicator [1].
Does the ABS indicator indicate the code "61 or
62"?
YES
NO
07ZAJ-RDJA110
– Short circuit in Red/black wire
– Intermittent failure. Replace the ABS fuse
7.5 A (ABS MAIN) with a new one, and
recheck.
Battery voltage
07ZAJ-RDJA110
– GO TO STEP 4.
– Open circuit in Red/black wire between the
ABS modulator 25P connector and ignition
switch
– Faulty ABS modulator
– Power circuit is normal (intermittent failure)
ANTI-LOCK BRAKE SYSTEM (ABS)
[1]
R/Bl
[1]
R/Bl
[1]
20-23