Right Crankcase Cover - Honda NC700XA Service Manual

dummyhead dummyhead
3. AT/MT mode switch Input Line Open Circuit
Inspection
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
right handlebar switch connector [1] and PCM 33P
(Black) connector [2] terminals.
Connection: White/yellow – A27
TOOL:
Test probe
Is there continuity?
YES
NO

RIGHT CRANKCASE COVER

REMOVAL
Drain the engine oil (page 3-13).
Remove the following:
– Maintenance lid (page 21-6)
– Shroud/side cover (NC700XD) (page 2-14)
– Shelter/side cover (NC700SD) (page 2-15)
– Right engine side cover (page 2-30)
Disconnect the linear solenoid valve 4P (Green)
connector [1] and remove it from the ABS modulator
stay.
Disconnect the CKP sensor 2P (Red) connector [1] and
release the CKP sensor harness.
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
07ZAJ-RDJA110
– Replace the PCM with a known good one,
and recheck.
– Open circuit in the White/yellow wire
NC700XD:
[1]
W/Y
NC700SD:
[1]
W/Y
[2]
A27
[2]
A27
[1]
[1]
12-97