Honda NC700XA Service Manual page 222

dummyhead dummyhead
Rotate and hold the throttle grip [1] to the fully open
position.
Turn the ignition switch ON while holding the throttle
grip at the fully open position over 10 seconds.
The
diagnostic mode.
Measure the voltage at the combination meter 16P
(Gray) connector [1] of the wire harness side and
ground.
Connection: Red/blue (+) – Ground (–)
Standard:
Does the standard voltage exist?
YES
NO
ECM/PCM enters the
8 V or more (Every 5 seconds)
– Inspect the combination meter (page 22-
8).
– Replace the ECM/PCM with a known good
one, and recheck.
communication
[1]
PGM-FI SYSTEM
[1]
R/Bu
4-61