Honda NC700XA Service Manual page 466

dummyhead dummyhead
Install the reduction gear cover [1] and bolts [2], and
tighten the bolts.
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Coat a new O-ring [1] with engine oil and install it into
the groove in the TR sensor [2].
Install the TR sensor into the crankcase by aligning the
flat surfaces of the sensor and shift drum end.
Install the wire clip stay [1] and TR sensor bolt [2], and
tighten the bolt.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Coat a new O-ring [1] with engine oil and install it into
the groove in the shift control motor [2].
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
[1]
[1]
[2]
[1]
[2]
12-111
[2]
Align
[2]
[1]