Honda NC700XA Service Manual page 415

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
5. Shift Pedal Angle Sensor Output Line Short
Circuit Inspection
Check for continuity between the wire harness side
shift pedal angle sensor 3P (Black) connector [1]
and ground.
Connection: Yellow/violet – Ground
Is there continuity?
YES
NO
6. Shift Pedal Angle Sensor Resistance Inspection
Measure the resistance at the sensor side shift
pedal angle sensor 3P (Black) connector [1]
terminals.
Connection: Yellow/red – Blue/green
Standard:
Operate the DCT shift pedal to check that the
resistance changes in accordance with the pedal
operation.
Connection: Yellow/blue – Blue/green
When moving the pedal up:
Resistance increases
When moving the pedal down:
Resistance decreases
Are the resistance inspections normal?
YES
NO
12-60
– Short circuit in Yellow/violet wire.
– GO TO STEP 6.
4 – 6 kΩ (20°C/68°F)
– Replace the PCM with a known good one,
and recheck.
– Faulty shift pedal angle sensor, replace the
DCT shift pedal as an assembly.
[1]
Y/V
[1]
Y/R Bu/G
Y/Bu Bu/G