Honda NC700XA Service Manual page 670

dummyhead dummyhead
Remove the brake caliper [1] from the caliper bracket.
Remove the rear wheel (page 18-6).
Remove the caliper bracket from the swingarm.
Installation is in the reverse order of removal.
• Replace the sealing washers with new ones.
• Apply 0.4 g (0.01 oz) of silicone grease to the brake
caliper pin sliding surface.
• Install the brake hose eyelet stopper against the
caliper body.
• Route the hoses and wire properly (page 1-25).
TORQUE:
Brake hose oil bolt:
34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill the reservoir to the upper level and breed the rear
brake system:
– NC700X/S (page 19-9)
– NC700XA/XD/SA/SD (page 19-12)
Check the air gap between the rear wheel speed sensor
NC700XA/XD/SA/
and pulser ring (page 20-24).
SD:
DISASSEMBLY/ASSEMBLY
Disassemble the rear brake caliper as following the
illustration.
• Be careful not to damage the piston sliding surface.
• If the caliper pin boot and sleeve boot are hard or
deteriorated, replace it with a new one.
NC700XA/XD/SA/SD shown:
CALIPER PISTON
BRAKE PADS
DUST SEAL PISTON SEAL
PAD SPRING
[1]
BLEED VALVE
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
CALIPER BODY
CALIPER PIN
27 N·m (2.8 kgf·m, 20 lbf·ft)
STOPPER RING
SLEEVE
BOOT
HYDRAULIC BRAKE
BRAKE PAD PIN
17 N·m (1.7 kgf·m, 13 lbf·ft)
19-31