Honda NC700XA Service Manual page 391

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
2. EOT Sensor Inspection
Turn the ignition switch OFF.
Disconnect the EOT sensor 2P (Black) connector.
Short the wire harness side EOT sensor 2P (Black)
connector [1] terminals with a jumper wire [2].
Connection: Blue/green – Green/yellow
Turn the ignition switch ON.
Check the EOT sensor with the HDS pocket tester.
Is about 0 V indicated?
YES
NO
3. EOT Sensor Input Line Open Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
EOT sensor 2P (Black) connector [1] and PCM 33P
(Black) connector [2] terminals.
Connection: Blue/green – A19
TOOL:
Test probe
Is there continuity?
YES
NO
4. EOT
Inspection
Disconnect the PCM 33P (Gray) connector.
Check for continuity between the wire harness side
EOT sensor 2P (Black) connector [1] and PCM 33P
(Gray) connector [2] terminals.
Connection: Green/yellow – B22
TOOL:
Test probe
Is there continuity?
YES
NO
12-36
– Faulty EOT sensor.
– GO TO STEP 3.
07ZAJ-RDJA110
– GO TO STEP 4.
– Open circuit in the Blue/green wire
Sensor Ground Line
07ZAJ-RDJA110
– Replace the PCM with a known good one,
and recheck.
– Open circuit in the Green/yellow wires
Bu/G
[1]
Open Circuit
[1]
[1]
Bu/G G/Y
[2]
A19
G/Y
B22
[2]
[2]