dummyhead
dummyhead
Disconnect the rear wheel speed sensor 2P (Gray)
connector [1].
Release the rear wheel speed sensor 2P (Gray)
connector from the ECM box [2].
Release the clamp [3].
Remove the socket bolts [1] and brake hose guide [2].
Release the brake hose [3] and rear wheel speed
sensor wire [4] from the brake hose guide.
Remove the clamp [1] and release the rear wheel
speed sensor wire [2].
Remove the bolts [3] and rear wheel speed sensor [4].
Clean around the mounting area of the caliper bracket
thoroughly, and be sure that no foreign material is
allowed to enter the mounting hole.
Installation is in the reverse order of removal.
Route the wire and hoses properly (page 1-25).
TORQUE:
Step holder mounting socket bolt:
32 N·m (3.3 kgf·m, 24 lbf·ft)
ANTI-LOCK BRAKE SYSTEM (ABS)
[1]
[2]
[4]
[3]
[4]
[3]
[2]
[3]
[1]
[1]
[2]
20-27