Seat Cowl - Honda NC700XA Service Manual

dummyhead dummyhead

SEAT COWL

REMOVAL/INSTALLATION
Remove the following:
– Single seat (page 2-7)
– Grab rail (page 2-8)
Remove the socket bolts [1] and trim clips [2].
Release the seat cowl front side slits [3] and tabs [4] from the side cover tabs [5] and slits [6].
Remove the seat cowl assembly [7] by releasing the its rear side tabs [8] and slits [9] from the rear fender B slits
[10] and tabs [11].
Installation is in the reverse order of removal.
DISASSEMBLY/ASSEMBLY
Remove the center seat cowl (page 2-8).
Remove the seat cowl assembly screws [1] and separate the right and left seat cowls [2].
Assembly is in the reverse order of disassembly.
TORQUE:
Seat cowl assembly screw:
0.9 N·m (0.1 kgf·m, 0.7 lbf·ft)
FRAME/BODY PANELS/EXHAUST SYSTEM
[11]
[5]
[6]
[4]
[2]
[1]
[10]
[2]
[9]
[2]
[3]
[7]
[8]
[1]
2-9