Honda NC700XA Service Manual page 560

dummyhead dummyhead
Install the left step holder [1] and step holder mounting
socket bolts [2].
Tighten the step holder mounting socket bolts to the
specified torque.
TORQUE: 32 N·m (3.3 kgf·m, 24 lbf·ft)
Install the drive sprocket [1], washer [2] and drive
sprocket bolt [3].
Tighten the drive sprocket bolt to the specified torque.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Install the ground cable [1] and starter motor mounting
bolt [2].
Tighten the mounting bolt securely.
Install the starter motor cable [3] and starter motor
terminal nut [4].
Tighten the starter motor terminal nut to the specified
torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Reposition the rubber cap [5] properly on the starter
motor terminal.
Install the fuel feed hose [6] to the clamp [7].
Align the fuel feed hose White paint with clamp.
Connect the clutch cable [1] to the clutch lifter arm [2].
Install clutch cable guide [3] and bolts [4].
Tighten the bolts securely.
ENGINE REMOVAL/INSTALLATION
[1]
[1]
[3]
[3]/[4] [7]
[5]
[2] [1] [3]
[4]
[2]
[2]
[1]/[2] [6]
16-17